Postby nervewrecker » April 2nd, 2013, 6:51 pm
Thread was going so good....
Anyways, if you dont know how to wire to an amp you should have bought a normal head unit and run them comps passive. You dont even know how to wire speakers to an amp much less use the TA, xovers, slopes etc.
As said before, make sure deck on network mode and make sure amps wired up properly (ie no turn on / off pops or kiss your tweets good bye). Refer to the manuals for both items on how to install.
The deck front out becomes high for tweets, rear becomes mid and sub is still sub.
One driver goes per channel on the amp but make sure the respective driver is on the respective channel that the respective RCA from the respective output it run to. Each channel on the amp is a pair of + & - connection. Make sure all + goes to + of speaker and - goes to - on driver.
Highs to mid is ok if you mix it up but mid to tweet or bass to tweet = goodbye tweet as you have forfeited the use of your passive network that could eliminate such blunders.
I assume your sub is a single sub so it will be in the sub channels bridged.
Set slopes and xovers accordingly. Angle drivers to suit you and find another thread on how to TA or use the auto eq (I would suggest manual anyday).
Last but not least and most important, please read the manuals.