WTK: cold solder

shiva_0001 · Postby **shiva_0001** » May 3rd, 2012, 2:09 pm

I have a 5 channel amp and when the bass gets loud it cuts off, I decided to repair it and it turned out to be cold solder
Now the problem has happened again I am am 100% sure its the cold solder, is there any thing I can do to prevent it from re occurring when I get it fix?

Postby **crazybalhead** » May 3rd, 2012, 2:13 pm

IF it was a cold solder, then anybody competent just has to redo the solder and it should be good to go.

shiva_0001 · Postby **shiva_0001** » May 3rd, 2012, 2:20 pm

well it did work perfectly until this morning it started effing up same way as before

Postby **nervewrecker** » May 3rd, 2012, 2:26 pm

while we on the topic:

got an amp at home, 2 of the channels play soft. It was working fine, I had it uninstalled and put aside for a few months. upon reinstall both channels play soft.

cold solder maybe? who can check it out for me?

shiva_0001 · Postby **shiva_0001** » May 3rd, 2012, 2:33 pm

check rohit 3739849 buh he fone switch of now try a lil later
i put the wrong # before by mistake

EDITED

shiva_0001 · Postby **shiva_0001** » May 4th, 2012, 9:00 am

going to get the amp soldered today.....think i am going to try installing a fan in it...has anyone done this?

a little louder · Postby **a little louder** » May 4th, 2012, 11:21 am

if you switch it off and go to sleep will it play the next morning

shiva_0001 · Postby **shiva_0001** » May 4th, 2012, 2:26 pm

ok problem is not amp stop working.....the bass channel plays softer than usual and when songs with a deep bass plays the amp cuts off, and then i have to turn off the deck and turn it back on for it to work again...sometimes it plays good some times it plays soft,well since yesterday...bass stated to sound weird too

shiva_0001 · Postby **shiva_0001** » May 4th, 2012, 2:56 pm

bumpyyy

shiva_0001 · Postby **shiva_0001** » May 5th, 2012, 4:54 pm

just got the amp .... working perfect ..... wanna know how to install fan?

Postby **nervewrecker** » May 5th, 2012, 6:52 pm

what was wrong with tit?

shiva_0001 · Postby **shiva_0001** » May 5th, 2012, 7:18 pm

cold solder .... but is the second time...Rohit told me though that he left it on for a few hours and it start back giving trouble soo he had to do all the below and thing but i still wanna install a fan in case it happens again

so far the amp work good since i got it back....i may install a fan or sell it