Moderator: 3ne2nr Mods
mongo wrote:Looking forward to the enclosure build and reviews.
nervewrecker wrote:Is just me or anyone else notice 0 vents in the plan?
I just playing around man, keep us updated.
kurpal_v2 wrote:mongo wrote:Looking forward to the enclosure build and reviews.
Indeed.
This little bugger is quite impressive.
Kongorealm wrote:Very good detail build and review Team ADT...I have watched this sub and will definitely be purchasing one of these (12" though) once funds are available!
One question: Did you get the opportunity to test the sub on the meter (spl)?
niceness...thinking about a 15"
TEAM ADT wrote:32.5v @ 1ohm
VOLTS x RESISTANCE = CURRENT
32.5v x 1ohm= 32.5amps
VOLTS x CURRENT= WATTS
32.5v x 32.5amps= 1056.25wrms (max, average was within 800-950wrms)
nervewrecker wrote:TEAM ADT wrote:32.5v @ 1ohm
VOLTS x RESISTANCE = CURRENT
32.5v x 1ohm= 32.5amps
VOLTS x CURRENT= WATTS
32.5v x 32.5amps= 1056.25wrms (max, average was within 800-950wrms)
In the future: V/R = I
Anyways, is that peak voltage, average voltage & how did you check it?
How was the impedance rise measured & drop in current / power delivered to the sub as well?
It's a new type of vent, from us here at Team ADT.We have alot of ways we do things differently, and this new enclosure will incorporate alot of our new design philosophy.
We have a .80cu^ft box before displacements, port area vs vent velocity simulates very well at fourteen square inches.The box has a nice response, -3db @ 28hz,0db @ 33hz,+3db @ 35hz, and peaks at +6 db @ 40hz.Please not the box is tuned to 38hz.
Return to “I.C.E. / Car Audio Tech”
Users browsing this forum: No registered users and 17 guests