Moderator: 3ne2nr Mods
I have seen a head that had to be thrown away, after a "butcher" from a famous local machine shop finished with it...CD4Accord wrote:Dremel I have, flywheel sander I can get... Worth considering but I just don't trust myself enough..
I guess that I could take a look and make a decision.. Have to learn at some point
yakuza wrote:OP unless you just cleaning up the casting imperfections, head porting without a flow bench is guess work.... you may end up lowering the CFM in the process.
Sanctifier wrote:IMHO do NOT try anything more than a simple "gasket matching" job
BTW Dremmel may not be powerful enough.
red_dragon wrote:^ contact Rado on the forum
Users browsing this forum: No registered users and 15 guests