Forums

Thank you for your response. Still looking around for info.

Does anyone have experience with this ecu? Wiring, tuning etc.?

WTB: Front brake rotors for a 2010 BMW E90, 320i. Can you contact me at 350-5061. Thank you.

Sounds like incorrect plugs or Faulty O2 Sensor. Use the Denso plug (OEM). There are alot of complaints with the NGK replacement. Also that engine uses either 5W-30 or 10W- 30. In worst case scenario a faulty injector/ fuel pump, but I mostly see this on GDI engines. Let someone ready you fuel trim,...

Yes I do and now I have a misfire on Cylinder 3 even though I changed plugs & Coils, cleared the code, it popped up again after a day. Do you guys do servicing? It looks like a lean condition.

Ok great. Thank you for your response. I always used premium, but having a little issue with rough idle, mainly on cold starts, so I was just wondering if fuel would have been an issue.

Good day, what fuel octane is required for the N43B20 engine? Is it Super 92 or Premium 95? I know it's a high compression engine. Thank you.

Yip so far everything on the mark, but I did notice that the gasket between the intake and head is a bit thick than it use to be, so I think i will try making a gasket with a thinner material and try it again. Thank you again for your help.

I didn't install the throttle cable just yet and the it seems to go all the way back.

I checked and it's not pulling in anything. I put back up the original carb & manifold and it runs normal. Do you think the valves need to be adjusted? It's not making noticeable noise, but just a thought.

Each barrel has it's own mixture screw. Both carbs are in sync, so there is only one idle screw. If I turn it up a bit it would idle high. Once I rev it it would stay at a high RPM, then I would have to back out the idle screw. When I do that it wouldn't idle. I'm out of ideas

Last night I pulled them off & replaced all the gaskets, so I'm pretty sure they are sealed, but thank you for your response. I do appreciate it.

I just setup twin side drafts on a B11. The carbs were rebuild, but they don't idle. It revs and idles only on higher RPM. I would appreciate any advise. Thank you.

Help?

Help anyone? Thanks.

Can anyone assist me with the pinout diagram for this engine. Any help would be appreciated?

Thank you.

Please call me at 350-5061 or PM. Thank you in advance.

Yes that is correct. I have an extra engine, with no help but would love to fit it in a b11 sunny that we had from brand new. Thank you.

Any help would be appreciated.

I tried him, but those doors weren't in the best of condition. He wanted like $800.00 for one. Thanks.

Good day. Does anyone have foreign doors for sale? Thanks.

Anyone have foreign doors for sale?? Send me a PM. Thanks.

Does anyone know where I can get foreign doors? Thanks.