Moderator: 3ne2nr Mods
X_Factor wrote:its soo refreshing to see ppl using proper firewall cable glands .
wire loom generally breaks down over time with the constant engine heat, you could consider expandable PET braid (aka techflex)
Rainman wrote:1. Why no dampening? there are endless gaping spaces in your door; unless you're not expecting any midbass in your front stage.
2. Great idea using plug n play harnesses, but please don't use those god-awful butt-splice connectors. Take some time and practice your solder/heatshrink skills.
3. Where are you mounting the tweeters? off/on-axis?
4. Any plans for additional processing?
5. Prime and repaint the speaker opening you grinded.
Other than that, good luck with the build. I'm subscribed.
SR wrote:So i now got a chance to read thru this build log.
Why use an 8ohm speaker on an amp designed to run at a 4ohm or 2 ohm load? Also what is the freq bandwidth response of the driver as you are not damping the doors and i doubt it will perform efficiently below 100hz so there will be a dip in the midbass to upper bass freq on the overall response from the system
SR wrote:Going good so far i like to see diy builds with people trying to do it on thier own and not afraid to share.
Users browsing this forum: No registered users and 6 guests