Moderator: 3ne2nr Mods
SR wrote:Jbl ms8 is only 2.8 volts out so keep the line driver
SR wrote:Jbl ms8 is only 2.8 volts out so keep the line driver
Ted_v2 wrote:Ditch the head unit, processor and linedriver and get something that does it all. Simplify the system, I know about rca failing and making you scrap 60 percent of the system to figure out the odd static, popping ect.
I guess a good installer is key
anythingforreal wrote:sub wise. what frequency should i tune too that would play good for a wide range of music?
nervewrecker wrote:Id say go for cone area since power is an issue. but 1 10" and 2 8" are roughly same.
Have the same amplifier, had it on a 10", its ok for what it is.
anythingforreal wrote:nervewrecker wrote:Id say go for cone area since power is an issue. but 1 10" and 2 8" are roughly same.
Have the same amplifier, had it on a 10", its ok for what it is.
what was the sub impedance you used if you dont mind me asking? Dual 4 ,dual 2 or single 4ohm?
saw the sub channel on the amp is rated @ 300 rms At 2ohm and 4ohm. so was wondering which would be better to use?
nervewrecker wrote:Id say go for cone area since power is an issue. but 1 10" and 2 8" are roughly same.
Have the same amplifier, had it on a 10", its ok for what it is.
For referencegt4tified wrote:nervewrecker wrote:Id say go for cone area since power is an issue. but 1 10" and 2 8" are roughly same.
Have the same amplifier, had it on a 10", its ok for what it is.
I thought 2x8" cone area is actually closer to 1 x 12"? Or was I wrong?
nervewrecker wrote:Id say go for cone area since power is an issue. but 1 10" and 2 8" are roughly same.
Have the same amplifier, had it on a 10", its ok for what it is.
anythingforreal wrote:nervewrecker wrote:Id say go for cone area since power is an issue. but 1 10" and 2 8" are roughly same.
Have the same amplifier, had it on a 10", its ok for what it is.
do you experience any kind of over heating from this amp? Tested the amp a few days back to make sure everything is working and during the 15mins worth of playing (gain on quarter) it heated up rather quick. Any thoughts or advice here or is this normal?
Looking at a zapco amp as well - ST - 6x Sq 6 channel and a ST - 105d bt( anyone one here ever used these amps?
any thoughts?
anythingforreal wrote:
Looking at a zapco amp as well - ST - 6x Sq 6 channel and a ST - 105d bt( anyone one here ever used these amps?
any thoughts?
Return to “I.C.E. / Car Audio Tech”
Users browsing this forum: Google [Bot] and 20 guests