Page 1 of 1

Advice needed on CS3 Lancer.....

Posted: May 13th, 2012, 5:49 pm
by unforgivensaint
Hey ppl i'm lookin to purchase a 2004 CS3 Lancer, i would like to know if this vehicle would be a good investment? as i would be very new to the whole Mitsubishi world. What are the pros and cons of this model? availability of parts?, price of parts? upgrades available.Thank in advance for all replies posted

Re: Advice needed on CS3 Lancer.....

Posted: May 13th, 2012, 8:46 pm
by Biggs3ne
Dude, there are plenty threads in this Forum that will give you all the info you need. Check the CS thread.

Re: Advice needed on CS3 Lancer.....

Posted: May 13th, 2012, 8:54 pm
by unforgivensaint
i stared to read that since last night, i'm jus lookin for some quick advice. Cause i wanna purchase this week

Re: Advice needed on CS3 Lancer.....

Posted: May 13th, 2012, 9:14 pm
by BrotherHood
I currently have one. Very good all round vehicle. Keep in that that the transmission not like the ordinary and it needs special care. Change the transmission fluid on time and only with the recommended grade of fluid (SP III).
Try to get a history of the car you are buying, especially the transmission and locally, people tend to abuse the CVT transmission that these CS lancers carry. Find out if any work was done on it.

Other than that, you should be fine. All this is irrelevant though, if the vehicle is manual.

Re: Advice needed on CS3 Lancer.....

Posted: May 14th, 2012, 12:36 am
by unforgivensaint
Thank you very much for the advice BrotherHood,it's an auto by the way.Question????, (1):should the transmission fail(God Forbid)what would be the price to replace it?,(2) if i want to up grade the engine from its present grade (13cc i think) what would u recommend?....Thanks again

Re: Advice needed on CS3 Lancer.....

Posted: May 14th, 2012, 11:19 am
by ZeroOne
Replacing tranny is about 8k if buying FU.

Engine upgrade depends on you/budget/etc.

A good conversion is 4g18 (1.6cc), it should be able to work with your current tranny as well

Re: Advice needed on CS3 Lancer.....

Posted: May 14th, 2012, 4:29 pm
by unforgivensaint
Thanks ZeroOne for your input as well

Re: Advice needed on CS3 Lancer.....

Posted: May 14th, 2012, 9:07 pm
by BrotherHood
unforgivensaint wrote:Thank you very much for the advice BrotherHood,it's an auto by the way.Question????, (1):should the transmission fail(God Forbid)what would be the price to replace it?,(2) if i want to up grade the engine from its present grade (13cc i think) what would u recommend?....Thanks again

The price to replace the transmission should it fail is approximately 7,8gran as ZeroOne pointed, and that is you buy it foreign used. If you are talking brand new, let's not go there. Let's just say that it's better off you buy another car. Diamond Motors will suck you dry. Don't believe me? get a quote yourself.
If you are looking to have it repaired, it depends on the damage to it. If we are looking at a complete rebuild, it will cost like 7gran, change bearings and flush the transmission, $5,500. Other than that the solenoids could need servicing. This will cost you around $1,200.
If such does happen, which we forbid will, Jenton's Transmission Specialist in Aranguez is a reputable repair garage for your transmission to be repaired.


About an engine upgrade, the 4G18 is a direct bolt up I believe (1600cc).I could be wrong. Someone else can con firm this. Good gas mileage and takes 3-3&1/2 quarts of engine oil.

Re: Advice needed on CS3 Lancer.....

Posted: May 14th, 2012, 9:13 pm
by Team Loco
At what mileage does the cvt oil need changing?

Re: Advice needed on CS3 Lancer.....

Posted: May 15th, 2012, 8:43 pm
by anthonyanthony
you said the engine is a 13cc you mean 1300cc.
the 1300 engine comes with a normal tranny , not a cvt which is only available in 1.6 models.

Re: Advice needed on CS3 Lancer.....

Posted: May 16th, 2012, 12:27 am
by unforgivensaint
OK, thks Anthony, is this tranny good? or does it have any issues?

Re: Advice needed on CS3 Lancer.....

Posted: May 18th, 2012, 1:41 am
by unforgivensaint
Ok car bought now i need a VERY RELIABLE mechanic around P.O.S and environs to service and stuff any recommendations??????????
(By the way it's a CS2A Model)