Is it possible to transfer all Body Parts from an Evo 9 to CS3 Lancer?

TheAutoDIYGuyYT · Postby **TheAutoDIYGuyYT** » January 4th, 2019, 4:03 pm

Hey guys, I was wondering if it was possible to transfer all Body Parts from an Evo 9 to CS3 Lancer? For example, Doors, Fenders, etc.
I know the frame itself is different in terms of structural rigidity, but in terms of mounting points and such, can the aforementioned be done without any modifications?

Postby **Dave** » January 4th, 2019, 4:35 pm

Front doors same. Back no because body line different to rear fenders. Front fenders are wider and finish by front lights would be different. Other line up not sure about.

black start · Postby **black start** » January 4th, 2019, 6:41 pm

Most men does just swap the firewall swap....

wagonrunner · Postby **wagonrunner** » January 4th, 2019, 8:42 pm

Dave wrote:Front doors same. Back no because body line different to rear fenders. Front fenders are wider and finish by front lights would be different. Other line up not sure about.

anything possible if the straightener has equipment and talent.
both seem to be in short supply locally.