Moderator: 3ne2nr Mods
30hz wrote:so.....
mechanic was changing out head on my 2003 cs3 4g18 sohc efi
camshaft gear/sprocket/pulley broke
cant find any for sale on classifieds
anyone here have links to find one, or can give me a part number???????
BoostJunkieXL wrote:30hz wrote:so.....
mechanic was changing out head on my 2003 cs3 4g18 sohc efi
camshaft gear/sprocket/pulley broke
cant find any for sale on classifieds
anyone here have links to find one, or can give me a part number???????
2954982 Mik
jason1984 wrote:Anybody know where I can get a thermostat for the 4G18 engine??? I checked most of the stores in the west and even diamond motors but nobody have any
Kronik wrote:Clean airflow, check/change spark plugs and air filter. But oxygen sensor is a culprit too
Jade_Inc. wrote:Iacv needs changing... There is nothing to adjust on the iacv.. What u can do as a temporary fix, on the throttle body, there is an 8mm nut under the X cable. You can adjust that Lil bolt to suit.. The downside to it, the idle wud be high when on park or neutral
nissan4life wrote:fwape this has been covered many times before, DO NOT adjust the idle screw especially when you have a mechanic that think is a carborated engine he dealing with, These screws are sensitive to the slightest of increments and should only be done with OBD scanner attached while monitoring the adjustments made.
Dave is correct, it can be cleaned
See link here to clean from idlemind
http://www.trinituner.com/v4/forums/viewtopic.php?f=33&t=458785
If this does not work, then replace. If you do a search on this forum you ll come up with the part number, cost of new unit is usually 400 up
jason1984 wrote:Anybody knows where I can get camber bolts for the cs3? Diamond motors don't have any
jason1984 wrote:Some strange ish happening to my CS3, whenever I hold the power window switch my headlights will dim and also my temperature gauge will go up. But when I let go the switch everything would be back to normal, could it be the battery or the alternator going?
fwape wrote:Need a lil advise from y'all fellas here. I have a 2005 CS3A 4G18 lancer that hsa been operating really bad when the A/C is on. when i idling in drive that shaking and making this kinda thunderous noise whenever the compressor switch, which is like every 10-15 seconds or so and the RPMs drop erratically. it usually idles at aroung 850-900 RPM but when the shate happening it just dropping to 600-700 and back up again.
Man that does be so bad i have to always put it in neutral when i idling in traffic. if i turn off the A/C all is well. I checked with one of my trusted mechanics who told me my idle control is off and just need to be readjusted but to me that not right. and since it blowing cold i doubt my compressor or condenser faulty. So what y'all think it could be? and thanks in advance.
tropi_flakes wrote:Good night people first time cs3 owner here but i think i bought an egg. I purchased one about a week ago for the wife to run around with ( daycare and work same area ) so i know its not gonna get any kind of abuse. The last car she had it 3 years and didn't even make a good 18000k on it. Anyways to sum it up the car works fine when the place is cool or open road, no overheating or anything but as soon as the place is really hot or in traffic and you stop and leave it in drive the car start to idle very very heavy, slap it in neutral and the idle is fine ( car dead silent) soon as you start to roll again and stop same thing heavy idle ( the temp gauge stays on half tho) so no over heating. Both fans are also work very good in the car evrything is fine unless in traffic or better yet if the car is on for more than 2 hours.
Also had one time i felt like there was delay in gearing down when i had to apply brakes suddenly, car came to a complete stop but you still felt the tranny gearing down to first
Engine in the car is the 1.8
Vehicle is a pce glx ( Singapore )
Call 2954982 ask for Mik. He can get it for youalcom2222 wrote:rique wrote:alcom2222 wrote:Good evening guys, looking for a fuel sending unit for a cs2 lancer, mines cant fix it have to be replace
last place i got mine was by partsman
contact:680-6646 located san juan
if not you going to have to look bamboo, you wont get this new.
Thanks for the help but I didn't get it by him, I check a few places and still no luck.
Anyone ?
Users browsing this forum: No registered users and 24 guests