Moderator: 3ne2nr Mods
mayinde wrote:Good day i have a reverse gear issue. When the car is now started the reverse gear won't engage till the car is fully warmed up. If i put it in reverse and mash gas before its fully up to operating temp the reverse gear goes in with a hard bang. Can anyone tell me what could be the cause. If anyone else has experienced this and what u did to solve it
X2Media Graphics Ltd. wrote:Seals in the transmission are worn. When it heats up it swells and builds pressure like it should. Revving builds high pressure to overcome leaks but its still too much so it slams into gear. You can either rebuild it with new seals or replace the transmission.
A few guys around but none specifically for Subaru.... Charles Transmissions, Jai, Jenton etc. Where u from? A rebuild can cost 10k+. I would suggest a foreign used especially if ur car is JDM. Am sure guys can give a review on a used transmission.mayinde wrote:That sounds like the solution. Who rebuilds transmissions for Subaru?
Around $3000-3500.mayinde wrote:Tobago. Well if is 10k plus forget it whats the cost of ah used one
When I changed mine it worked instantly I didn't know there was a procedure for this.25stouring wrote:Hey guys
Does anyone know of any reset proceedures for the auto feature on the legacy power window switch. I had replaced my switch panel (original had broken) with a foreign used one but the auto feature isn’t working. I tried the reset procedures that i saw on YouTube and on legacy gt forums which basically involves lowering the window then bringing it back up again and holding the switch for 10sec but it isn’t working. My car is an 05 LGT JDM.
Not sure if the proceedure is different for jdm or not
Thanks
janfar wrote:Where you guys get the switch to buy?
25stouring wrote:Hey guys
Does anyone know of any reset proceedures for the auto feature on the legacy power window switch. I had replaced my switch panel (original had broken) with a foreign used one but the auto feature isn’t working. I tried the reset procedures that i saw on YouTube and on legacy gt forums which basically involves lowering the window then bringing it back up again and holding the switch for 10sec but it isn’t working. My car is an 05 LGT JDM.
Not sure if the proceedure is different for jdm or not
Thanks
What price u paid if u don't mind25stouring wrote:janfar wrote:Where you guys get the switch to buy?
I bought mine at one of those places in the bamboo alongside grand bazaar...think it was bicks
Users browsing this forum: No registered users and 2 guests