TriniTuner.com | Latest Event:
Moderator: 3ne2nr Mods
elantra wrote:Not sure why it's not communicating, that's all the reader says. The obd port has 4 wires. Ground. Signal power not sure on the other. But all is good. At this point nothing is dumb na pal I checking anything lol, Fluid is good.
elantra wrote:Hey fellahs I got through with issue. It was the yaw sensor. Located below the driver seat.
The reason for the non communication with the reader was the +12v pin on the obd port was oxidized hence no contact. The electrician had check from where the wire was entering the port not from below where the jack plugs in. I cleaned it up and some electronic spray. Works perfect now.
Users browsing this forum: No registered users and 16 guests