Not sure if it is a repost but seen it on many a forum but don't think I have seen it here. Post up some pics of your engine bay, really only local pics please. Maybe some before and after pics and what was used to get the job done. Would like to see some of the local talent as I know some guys are really good when it comes to detailing. No pics off the Internet please. Let me start with my previous and current bays,
The good ole faithful GT after I removed the Boost,
My Pewter S15 at some point, a bit messy, haven't seen her since
My ER34 GTT,
My Subject S14.5 Spec SR,
This is a before shot,
Will get an after one at some point. Need to get the pipes chromed and some other brackets and whatnot powder coated. Usually I use something like Clean-Off mixed one to one with water and spray it on and allow to soak for about 30 minutes, it is not harsh on the paint and clear coat like purple blaster is as I have learned from my past episodes. After soaking I use a pressure washer in the spray pattern and wash it off, being careful not to get water where it should not be. After that is done I then use the compressor to blow out all connectors and coilpacks and whatnot. Then I go over plastics with either WD40 or some sort of Amorall very lightly as a thick film collects a lot of dust quickly. After that I will try and maintain it, rainy season is real pressur though.