Forums

mellod

D3 gives u from 1st - 3rd but from what i suspect doesn't allow torque converter lock up in 2nd and 3rd. but D gives u lock up in 2,3,4 & 5

mellod

it doesnt seem to be flaring its like driving over a rumble strip or a roughly patched road. thats the feeling and it happens between 1500 - 2000 rpm and i believe it happens when transmission goes into torque converter lock up. it doesnt happen it D3 but happens in D at the same rpm range

mellod

Hey guys just got a civic from japan R18a. Everything is else is great with the car just one issue. When i first drove the car I noticed that when it is about to shift (though i think it is on timing with Lock up) the car seems to shudder a bit between 2 3 4 around 1500 to 2200 rpm on very light thr...

mellod

Hey guy a friend of mine Is looking to by a cs2a however the owner said he was told his differential bearings are failing. Is it possible to change out these bearings or must the transmission be replaced

mellod

Hey ordered my sylphy but it only came with one key.

The key it came with is the ordinary key shape with the remote end not the smart key

Question can I just cut a key that would work or would I need to get a key from the dealer

mellod

Hey bro u could check the speed sensor or if u really want to go manual get the set up from the lancer ck2

mellod

any idea how to remove it and clean the contact or button itself. call dealer and they said i have to replace the entire gear shifter, but that doesn't make sense over 1 button.

mellod

how do you remove the S button/ O/D button on shifter i want to clean the switch.

mellod

I think you probably not feeling the difference. Next time you press the button press on the gas a bit and release, when you do this the RPMs should stay up and the car should cut back speed on it's own. Sports Mode burns more gas as well, just as Fearless noted. Yh I know it burns more gas i did s...

mellod

Hey guys just bought a sylphy from Japan g11 however i nnoticed that the sport button doesn't work. The light comes on when starting however when I press the button nothing happens. Any ideas y or anything that's common?

mellod

Hey guys just got my G11 from RORO MR20DE. Have a question. I know these cars are CVT and they carry a sport button on the gear lever but when i press mine it does not active. When i turn on the ignition though i see sport come up and goes off but when the button is pressed nothing happens. What cou...

mellod

I own an sir g. I took off the pipe I bought the car with and reverted back to original honda but used the type r muffler. How er I noticed that for some reason my tire rubs against it occasionally not sure if it was welded on properly. But it seems ok where it is. However I am putting some wider ti...

mellod

what parts apart from the ECT sensor can cause a drop in power when temperature changes

mellod

My car is auto forgot to mention that but i solved the problem. the kick down cable was adjusted and thats y i wasn't getting full throttle thanks for ur assistance red_dragon

mellod

will have to that a lil later it opens about half way like between 45 to 60 degrees from rest.

mellod

by opening both ways cuz i check it. when u open by cable and by turning the part the cable attached to

mellod

new to honda, ]

when u say the linkage u referring to the cable section or the spring section. and would the throttle stop screw prevent full throttle? i thought i was only for idle.

mellod

Hi guys did some throttle body cleaning on my sir-G and noticed that the throttle plate did not open 90 degrees. is this the way they are and if not is there a way to adjust.

mellod

hey guys need some help here. bought an integra Sir-G about a month ago. I noticed the car would drive for 9 miles without getting up to normal temp. when i investigated it didnt have a thermostat so i put one on. After this when we restarted the car the rev stayed at 2000rpm and when it got hot the...

mellod

I had a glance at the 1992-1995 galant and the 1996-2003 the suspensions look the same. but are the parts interchangeable?

mellod

can you re-up the cy models again

mellod

what do you think could be the problem. it engages really hard but only in reverse, D is normal

mellod

hey guys im just looking into buying a used lancer 1.5 glx however i went to look at it today and the guy said that it has been parked for 3 months with a dead battery, when we got it started everything sounded good however when i put it in reverse there is a strong jerk and a loud knock sound, howe...

mellod

Hey guys I own a sohc 4g63 galant but she is really slow have new plugs. A guy said that I could advance the cam position sensor and gain some power but I need some verification from u guys. I run a 0-100 kmh in around 13-14 sec which makes my dads non vtc almera a rocket. Any help would be greatly ...

mellod

I checked the uk website for ngk and they said that the 4g63 sohc for england came with platinum and iridium plugs, also there are 2 different power ratings 124hp 170nm and 134hp 178nm, i doubt plugs would make a difference that significant so i guess different computers, although my padna told me t...

mellod

Hey guys I own a supersaloon 2002 galant this one came with the manual ac switchs and nobs however the center console's material is getting soft and I wanted to change it however I didnt want to put the same material back and most of the silver and wood finished ones came with the auto ac. Has anyon...

mellod

Hey guys recently bought this car and love it. Finally i own a Mitsubishi lol. In the owners manual the car is supposed to use bkr6e-11 plugs, i read on a miata forum that with the miatas, switching from the bkr6's that their cars use and utilizing longer reach electrodes not threads, yielded a lil ...

mellod

I bought a timing belt for my 2.0 galant but the belt is about 5mm thinner than original. Would it be safe to use?

mellod

The shift solenoid?

mellod

Hey guys need some help. My dads almera qg16 auto recently started to stick in first. It doesnot do it all the time however the problem seems to be becoming more consistent. Recently when I drove it I notice it even redlines and not change. I tried easing of and running through D 3 2 L and neutral h...