Forums

Hey guys, Im looking for the strip that s on the bottom of the tail gate, anyone has one for sale or know where I can get one?

Cam sensor> or crank sensor...hook up to a diognostic machine anc check it..

air flow sensor...five hundred and somethnig for it..

hey brothers, morning, looking to change the front shocks on the y11. What do you all recommend? kyb or tokico?

Hey Guys, I have a fender glass to change on a wingroad, its one with a finisher rubber, unlike the ad wagon with no rubber, will double zee replace it?

Hey Bro,

Can you post a couple pics of the rims?
Or you can e mail to: ethan_ross@hotmail.com

Thanks Man...

pics please..

Thanks.

Well I was getting a knocking and rough ride from the suspension. I changed the stabaliser clamp bushing rubber and stabalizer link rubber, the car started to ride real sturdy BUT a squeak and knock appeared in jagged rough road... Im thinknig when i changed ther stabalizer link rubbers the stress w...

similiar problem with my QG15.....it starts....idles good then after 5 minutes of so it just cuts off..... check light on since january though......o2 sensor showing up on the scan....... mech says o2 sensor cannot cause this.....serviced car clean injectors changed plugs...service throttle body 6 ...

hey guys, having a lil prob with the qg15. Im hearing a rattling sound around by the water pump pulley and power steering pulley. its heaver when its idling in a gear and worse when it takes load when I put on the AC. it very well sounds like a bearing gone bad, im thinking the water pump bearing. E...

having a similar problem with my wingroad, engine light comes on, it cuts off when the rpm goes below 1000. I am thinking its bad gas. last time it happened, the diagnostic said cam sensor.
ethan_ross@hotmail.com

Never had the gas consumption problem though.. I make a princes town to POS and back and burn a little less than quarter tank. im a windroad, same engine i believe. But the car recently cut off a few tiems in traffic and proceeds to cut off when the rpm goes below 1000. Last time that happen was whe...

strange enough no punchin. 3 mins after I filled up at np thats it.. cut off. IT was a last resort with NP that day. Last time the diagnostic said cam sensor. changed it and it problem remained until the np gas burned out. Then started to work again with unipet gas. Im wondering if im the only one e...

Im getting the same problems again.. as soon as the RPM falls below 1000 car cuts off in traffic.. this happens every time i full np gas..I put a water remover/injector cleaner.. it stoppen and then start back 2 days after while on the hiway... Any ideas?

thanks man... it did not cut off this mornig, nor was the light on,if it comes back on i'll change it. im at ethan_ross@hotmail.com..

much thanks again

My wingroad (sane qg15) just cut off in traffic. and did it a few times before i got home, i hooked it up to a diagnostic tool and it said camshaft sensor. the engine runs and cuts off after idling for about 10 mins. I believe its the NP gas i put in the car that did that, bad gas im hoping after it...

I'm looking for the foglights for the Y11, the big sqauarish ones... is it those?

ok cool, thanks man, appreciate the advice...

if i go with a new rack, i wont be guaraneteed long service, could go in 3,4 or 5 months......what would you do?

hey guys, concerning the Y 11.mines has a slight pull to the left, and a constant shim on the steeting (left right) and that shim becomes a violent vibration at 80 to 100 and above. i thought it was wheel balancing and alignment so i did that and the pull eased up but didnt go away, the vibration is...

went by the parts place, guy told be i wont get a new rack and the kit may be a good bet..

did the tightening and it worked thanks....

hey guys, i was looking at your discussion concerning the Y 11. My y 11 has a sl;ight pull to the left, and a constant shim on the steeting (left right) and that shim becomes a violent vibration at 80 to 100 and above. i thought it was wheel balancing and alignment so i did that and the pull eased u...

getting a screaching sound when i lock all to the left or right..anyone know what that is?