Hello everyone, This is my first time posting to this website. I have a 97 Civic with a d16y8. I pulled the engine last year and rebuilt it (pistons,rods,springs,retainers,cometic gaskets,etc.)
After reinstalation into the car I added a cheap ebay turbo kit. Currently I cannot get the car running without ether. I have verified my ecu with a known good one, the main relay is functioning, the fuel pump is priming, the injectors are firing( I pulled them out with the rail and visually verified fuel was squirting) I have fresh gas in the tank, I have spark, I new plugs gapped accordingly. I have tried unplugging the map and other various sensors.
Im kinda at a loss here of where to go next. I have yet to test compression but seing as this is a fresh motor and its able to run on ether Ive kinda strayed from bothering to check. Any input would be apreciated. I will also note that the cel does stay on after key is turned and these are the codes
Previous owner swapped in a manual transmission and disconected all the auto stuff. Dont think this has anything to do either since the car ran before the rebuild.
Any input would be very much appreciated!