QG13 Problem

^^!SPAWN!^^ · Postby **^^!SPAWN!^^** » February 16th, 2011, 8:53 pm

Guys I need a lil advice on a problem I am getting with a QG13 Engine (E Throttle)

Yesterday it was driving fine , then all of a sudden it cut off , when I tried to start back it gave a hard start then the check light came on , tried to drive it and it was struggling to move forward , and the tone of the exhaust sounded funny to how it sounds now ( Sounds louder with the problem i'm getting ) .
I changed the air flow sensor and reset the check light and it came off , the car worked fine whole day up to tonight and it cut off again .

Any ideas ?
Thanks in advance .

^^!SPAWN!^^ · Postby **^^!SPAWN!^^** » February 16th, 2011, 10:01 pm

Anyone?

G20 · Postby **G20** » February 17th, 2011, 1:17 pm

My mech says to check the airflow jack has a break or check both the crank and cam sensor...

e-throttle sucks !!!

hong kong phooey · Postby **hong kong phooey** » February 17th, 2011, 2:14 pm

Did u check the error before u reset the checklight ?

as g20 sad it could be the air flow sensor to the cam or crank sensor . the diagnostic will show it

^^!SPAWN!^^ · Postby **^^!SPAWN!^^** » February 17th, 2011, 5:15 pm

No didn't check the error but when I changed the air flow sensor it worked fine until last night , today it worked fine with no problems ....

azoturbo · Postby **azoturbo** » February 18th, 2011, 12:57 am

get it scanned

rollingstock · Postby **rollingstock** » February 18th, 2011, 11:53 pm

Sounds like cam and crank sensor, if it is be minded that they're both the very same however some pars place have different prices for both even N&M

^^!SPAWN!^^ · Postby **^^!SPAWN!^^** » February 19th, 2011, 9:40 am

rollingstock wrote:Sounds like cam and crank sensor, if it is be minded that they're both the very same however some pars place have different prices for both even N&M

Thanks rollingstock
But do you have an idea of the price that they going for ?
I will get it scanned 1st but if it is those sensors I will know how much I would have to spend .

^^!SPAWN!^^ · Postby **^^!SPAWN!^^** » February 26th, 2011, 12:27 pm

Update :-
Went by Anil Sooknanan this morning for a diagnostic , it's the crank and cam sensor .

rollingstock · Postby **rollingstock** » February 26th, 2011, 2:49 pm

Well you went by the right guy, he has them for a great price, sorry for not replying to your earlier post, didn't get a topic reply notification.

^^!SPAWN!^^ · Postby **^^!SPAWN!^^** » February 26th, 2011, 2:56 pm

^^
Yeah he gave me a good price for them but unfortunately he's out of stock ....

rollingstock · Postby **rollingstock** » February 26th, 2011, 3:00 pm

Bought a pair some months ago by Mathura's in St James, can't remember the price, but they were lower than a lot of places and the only place that admitted that both sensor's are the same.