Moderator: 3ne2nr Mods
Duane 3NE 2NR wrote:kamakazi wrote:Isn't there an allowance for darker tint on the rear glass(tail gate and rear quarters) for station wagons and similar vehicles
All vehicles are allowed darker tint in the back but no lower than 20%
Everything beyond the B-pillar is defined as rear glass.kamakazi wrote:Diagram doesn't address the rear quarter glass on station wagons
shake d livin wake d dead wrote:Again...which shops?
Which shops have authorized meters?
Dum$!÷× laws
shake d livin wake d dead wrote:Again...which shops?
Which shops have authorized meters?
Dum$!÷× laws
sMASH wrote:shake d livin wake d dead wrote:Again...which shops?
Which shops have authorized meters?
Dum$!÷× laws
disagree, good law this time. problem is the roll out.
cause when u go to check ur tint, how are u sure that their meter is calibrated to meet LO meters?
aidan wrote:So most likely everyone who had 35% install in the past will be in violation? At least on the front doors
aidan wrote:So most likely everyone who had 35% install in the past will be in violation? At least on the front doors
nick639v2 wrote:My 20% ceramic read 9.8% today on the meter at N. Gopie marketing. And at any time of day the driver is clearly visible eh. So much for wanting specific % numbers. Now is pressure to rip this out and do over
sMASH wrote:And how, pray tell, would they be able to verify if they are in compliance? Ent not if they are able to verify it with calibrated meters? Where they getting their meters calibrated? Or are they supposed to lo to use their meters to ensure compliance?
Use this - for US$20+ you might want to buy your own. Certification samples are only good for one year.sMASH wrote:And how, pray tell, would they be able to verify if they are in compliance? Ent not if they are able to verify it with calibrated meters? Where they getting their meters calibrated? Or are they supposed to lo to use their meters to ensure compliance?
Request for Measuring Device VerificationVexXx Dogg wrote:Should these tint meters fall under the purview of the TTBS since they are responsible by law for Metrology?
Who knows... Rd4 cr-v with factory baked glass read 14% also. I'll redo my tint to the 35 and cross my fingers it follows the police meters.sMASH wrote:nick639v2 wrote:My 20% ceramic read 9.8% today on the meter at N. Gopie marketing. And at any time of day the driver is clearly visible eh. So much for wanting specific % numbers. Now is pressure to rip this out and do over
is their meter calibrated properly?
Return to “Ole talk and more Ole talk”
Users browsing this forum: alfa and 191 guests