Any FPV drone men here, need some help with betaflight

15devils · Postby **15devils** » October 20th, 2020, 5:52 pm

as the topic states, accidentally hit reset on betaflight and my settings and everything is gone,how can I get it back ? its a tinyhawk2 rtf kit.

Postby **Duane 3NE 2NR** » October 20th, 2020, 6:08 pm

15devils wrote:as the topic states, accidentally hit reset on betaflight and my settings and everything is gone,how can I get it back ? its a tinyhawk2 rtf kit.

You ever backed up the Betaflight settings in the BF Configurator?
If you did then you can do a restore
https://oscarliang.com/backup-restore-b ... ht-config/

maj. tom · Postby **maj. tom** » October 20th, 2020, 6:17 pm

Without your settings backed up, i don't think so. If it's bricked, from what i'm reading you have to manually re-flash the firmware to factory settings:

https://emaxusa2.freshdesk.com/support/solutions/articles/19000108267-tinyhawk-manuals-cli-firmware-for-rtf-bnf-v1-v2

Then still following the same instructions there, copy the CLI dump text into the CLI tab in Betaflight Configurator. Save and reboot and then rebind the drone to your controller.

Good Luck.

15devils · Postby **15devils** » October 22nd, 2020, 7:34 pm

well I got a cli file on emax usa website, and did the cli dump and got back everything working , its just i find the trottle stick needs more push for the drone to be controlled. I would look for some tuned pid settings and see if it helps, thanks for the info fellas.