Postby biggy82 » March 27th, 2011, 2:30 pm
there are two screws on either side of the bottom of the centre console finisher. remove those. prise up the ashtray / coinholder at the top and you will see a small screw. more likely than not this screw will come out before you try to unscrew it. DO NOT LOSE THIS SCREW!!!! it may seem insignificant but it is important later.
CAREFULLY prise up each side of the finisher till it pops out of the dashboard. remove the clips for the AC and hazard light electricals and set aside the finisher. there should be 3 visible screws holding the deck in place. remove them and you can then remove the deck
after installing your new deck, reverse the procedure. install the 3 screws to hold down the deck, insert AC and hazard light electrical plugs, then line up the finisher and snap into place. remember the lil small screw? well line it up and install it. if you do not screw this into place properly, the finisher will be misaligned just enough to hamper the screen of the deck from opening / closing properly (yes, it happened to me). then snap the ashtray / coinholder back in place and install the bottom finisher screws