Throttle body question

mellod · Postby **mellod** » March 29th, 2014, 9:51 am

Hi guys did some throttle body cleaning on my sir-G and noticed that the throttle plate did not open 90 degrees. is this the way they are and if not is there a way to adjust.

red_dragon · Postby **red_dragon** » March 29th, 2014, 1:01 pm

Check the linkage or throttle stop screw

mellod · Postby **mellod** » March 31st, 2014, 12:41 pm

new to honda, ]

when u say the linkage u referring to the cable section or the spring section. and would the throttle stop screw prevent full throttle? i thought i was only for idle.

red_dragon · Postby **red_dragon** » March 31st, 2014, 3:00 pm

^ correct

I made error

forgot to ask u opening by hand or with the throttle cable connected?

mellod · Postby **mellod** » March 31st, 2014, 3:09 pm

by opening both ways cuz i check it. when u open by cable and by turning the part the cable attached to

red_dragon · Postby **red_dragon** » March 31st, 2014, 5:40 pm

post a pic of where the linkage is stopping

mellod · Postby **mellod** » March 31st, 2014, 5:59 pm

will have to that a lil later it opens about half way like between 45 to 60 degrees from rest.

mellod · Postby **mellod** » April 4th, 2014, 2:10 pm

My car is auto forgot to mention that but i solved the problem. the kick down cable was adjusted and thats y i wasn't getting full throttle thanks for ur assistance red_dragon