Moderator: 3ne2nr Mods
Redman wrote:dont think so....making a water rocket and the material is for the fins...light and tough.
the waves on the PG wouldnt be suitable...I think.
nos_specialist wrote:Redman wrote:dont think so....making a water rocket and the material is for the fins...light and tough.
the waves on the PG wouldnt be suitable...I think.
OHHHH, i know what you can use......
there is a material sign companies use, thin PVC sheets, u can mark it with a knife and cut it, its hard and durable as well as lightweight....check that out...
kripplerz wrote:I paid about 180 for a length of angle. I used 5 lengths for the standing shelf and 2 for the rolling one.
And the ply can't remember the exact price for it I guessing about $160
So 7x180=$1260 for the steel. Plus the ply.
kripplerz wrote:Anyone ever had any experience servicing a ring stove. I have one and it's not lighting properly in some spots, it's been packed down a while and bits of rust on it.
I'm thinking if I go trough all the holes with a small drill bit just to clean the port and then blow it out with some compressed air. What you all think.
Sent from my iPhone using Tapatalk
ruffneck_12 wrote:
Was hunting around the house to find some old pill bottles to store small screws and sheit, but wasnt find any. Gonna make these from now, save time and money.